The sensing material of MIX1007B is tin dioxide SnO2, which has low conductivity in clean air. When the Carbon Monoxide(CO) gas exists, the conductivity of the sensor will be raise according to the gas concentration goes up. Through a simple circuit, to convert the changes of conductivity to correspond to the gas concentration.
MIX1007B Carbon Monoxide(CO) Gas Sensor has high sensitivity to carbon monoxide. The sensor can work in high temperature. It is low cost sensor and can be used in different applications.
High sensitivity to wide range of carbon monoxide
Long life and low cost
Domestic gas leakage detectors
Portable gas detectors
Technical Parameters :
|Target Gas||Carbon monoxide|
|Measurement Range||10~500ppm CO|
|Heater Voltage(VH)||5.0V±0.1V AC or DC (high temp.)|
|1.5V±0.1V AC or DC (low temp.)|
|Heater Time(TL)||60 S±1S (High temp.)|
|90 S±1S (Low temp.)|
|Loop Voltage||≤24V DC|
|Heater Resistance(RH)||30Ω±3Ω(Room temperature)|
|Heater Power Consumption(PH)||≤900mW|
|Sensitivity||RS(in air)/RS(150ppm CO)≥ 5|
|Output In Target Gas||2.5~4.3V(in 150ppm CO)|
|Concentration Slope(α)||≤0.6(R300ppm/R50ppm CO)|
|Oxygen concentration in used place||21%, no less than 18%|
|If used in low oxygen concentration, pleasure contact for detail|
|Life Expectancy||10 years|
When soldering the metal ribbons, the soldering tin was forbidden to contact with the sensor.
* Aging the sensor no less than 30 mins before operation；
* Keeping the sensor out of the volatile solvent.
* Prohibit storage and operating the sensor in acidic or alkaline environment.