Shenzhen Mixsen Electronics Co.,Ltd. 86-185-6625-9936
MIX8011 Electrochemical Carbon Monoxide(CO) Gas Sensor

MIX8011 Electrochemical Carbon Monoxide(CO) Gas Sensor

  • High Light

    Mixsen 1000ppm electrochemical gas sensor


    MIX8011 electrochemical gas sensor


    electrochemical carbon monoxide detector

  • Principle
  • Range
  • Target Gas
    CO/Carbon Monoxide
  • Lifetime
    10 Years
  • Place of Origin
  • Brand Name
  • Model Number
  • Minimum Order Quantity
  • Packaging Details
    Inner packaging: foam cushion Outer packaging: carton
  • Delivery Time
    within 3 working days after payment
  • Supply Ability

MIX8011 Electrochemical Carbon Monoxide(CO) Gas Sensor

Principle Introduction:MIX8011 Electrochemical Carbon Monoxide(CO) Gas Sensor

Carbon Monoxide ( Co ) gas sensor is electrochemical gas sensor,the concentration of the gas could be get by measuring value of current.We have different types of CO sensors, except the sensor, we also have modules and we can supply one-stop gas sensor solutions.The most hotsale type of co sensor is:MIX8012,MIX8011,MIX8015,etc.The life of the co sensor are 3 years,7years,8years,10years.So just tell us your detail need,we can meet your different needs and send you price asap.



High selectivity and sensitivity to CO , High accuracy , Linear output ,Long life ,Environmental protection design



Residential and commercial ,Industrial monitors ,Indoor underground parking ,Houseboat and moto home ,Fire detection ,Ventilation control ,Domestic generator


Technical Parameters :


Item Specification
Target Gas Carbon monoxide
Measurement Range 0 ~ 1000 ppm
Maximum Overload 2000 ppm
Output Current 1.5-3.5 nA/ppm
Repeatability ±2%
Resolution 0.5 ppm
Response Time(T90) < 60 S
Long Term Output Drift < 2% /month
Lifetime 10 years
Operating Temperature Range -20 ~ 50˚C
Operating Humidity Range 15 ~ 90% RH
Operating Pressure Range 0.1MPa±10%
Recommended Load Resistor 1kΩ
Bias Voltage Not required
Note: All measurements were taken at 20˚C, 50%RH at 1013hPa


Operating Note:

* When soldering the metal ribbons, the soldering tin was forbidden to contact with the sensor.
* Aging the sensor no less than 30 mins before operation.
* Keeping the sensor out of the volatile solvent.
* Prohibit storage and operating the sensor in acidic or alkaline